Hotend pauses on print for a few seconds after finish printing

Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!

Pauses in 3D printing: inserts and color changes

Filament extrusion always stops at some point during print - 3D Printing Stack Exchange

Extruder jams/clogs up after printing a little bit of filament – Hardware, firmware and software help – Prusa3D Forum

Bowden vs Direct Drive Extruders Comparing 3D Printer Configurations

Professional desktop 3D Printer from CreatBot F430

Snapmaker J1 3D Printer - Dual Extruder IDEX 3D Printer- Snapmaker

Eliminate pauses between one-at-a-time objects - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Is The J1 IDEX 3D Printer Worth Investing In? by Us Sapmaker - Issuu

Printer pausing 1-3 sec every ~10 print moves

Simplify 3D® Software MakerGear - MakerGear™

Removable Extruder Pulls Out The Stops On Features

Is your 3D printer extruder clicking? Here is how to fix it