Rise, Run, Tread, Nosing, and Width of a Stairway - Inspection Gallery - InterNACHI®

Rise, Run, Tread, Nosing, and Width of a Stairway: The tread depth should be at least 10 inches (254 mm). The tread depth is measured horizontally between the vertical planes of the foremost projection of adjacent treads and at a right angle to the tread’s leading edge. The greatest tread depth within any flight of stairs or stairway should not exceed the smallest by more than 3/8 inch (9.5 mm). The riser height is at most 7 and 3/4 inches (196 mm). The riser is measured vertically between leading edges of the adjacent treads. The greatest riser height within any flight of stairs or stairway shall not exceed the smallest by more than 3/8 inch (9.5 mm).

Inspecting Stairways, Railings, and Guards at Commercial Buildings - CCPIA

stairs Search Results - Inspection Gallery - InterNACHI®

stairs Search Results - Inspection Gallery - InterNACHI®

stairs Search Results - Inspection Gallery - InterNACHI®

stairs Search Results - Inspection Gallery - InterNACHI®

Project Source 2.37-in x 78.7-in Harrison Finished Laminate Stair Nosing in the Stair Nosing department at

Stairway Inspection – InterNACHI Inspection Narrative Library

1910.25 - Stairways. Occupational Safety and Health Administration

Interior > General - Inspection Gallery - InterNACHI®

Quick Inspection Tip: Stair Risers & Treads

Deck - building and safety - Prism Home Inspections

Stair tread depth? - Interior Inspections - InterNACHI®️ Forum